LCN-GTS6C Issendoroff KG

This Tweezers The LCN-PINZ is a special tweezers designed for unlocking the LCN glass surface buttons. These buttons are equipped with a lateral locking pin that can be easily removed with the tweezers without causing damage. This greatly facilitates the installation and maintenance of the buttons. Application Examples Installation of LCN glass surface buttons Maintenance and replacement of buttons without damage Technical Data Ergonomic design for easy handling Material: High-quality plastic

Sensor/Actuator module for flush-mounted installation Combined sensor/actuator module with two electronic switching outputs 230V, 300VA. Dimmable in phase-cut or as a switch (switches at zero crossing). The 8 button inputs can individually control 64 target addresses with 192 functions. Integrated pulse measurement input for remote control receivers. The built-in operating program includes the following functions: switching and dimming of the outputs, brightness and change speed can be set separately. Includes programs for incandescent lamp dimming, roller shutters, gates, etc. Evaluation via 5 thresholds (=10 commands) with hysteresis. Includes 2 continuous controllers that can be used independently and in addition to threshold processing. Two measured values can be captured and controlled independently of each other. Decoding of telegrams from the IR remote control receiver or transponder. Evaluation directly or via central computer. Functions for button levels, coded transmission, sender differentiation. Additional functions: control with dependencies, formation of links, counting, calculating, fixed and dynamic group formation, generation of automatic status messages (real feedback) for visualization. LCN System Bus Functions Communication with up to 30000 modules, max. 250 modules per bus level. Protocol with collision avoidance Documentation and parameterization retrievable in the module memory 100 light scene memories available per output Connection options for EIB/KNX touch sensors (standard), DSI-Dali interface, relays Overload protection, the outputs switch off consumers at excessive loads Note: UPP modules must not be connected directly to roller shutter or blind motors! The limit switches or the triacs in the module may be damaged. The use of the relay LCN-R2U is recommended. A filter (LCN-FI1) is mandatory as soon as the electronic outputs of the LCN-UPP are used as dimmers. The interference filter is connected between the module and the consumer, dampening the disturbances that occur during dimming, thus ensuring compliance with CE standards. Technical Data Integrated power supply 230V ±15%, 0.4W, pulse-resistant up to 4kV. Flush-mounted housing connection via approx. 20cm long single wires 0.75mm². Dimensions: 50mm Ø x 20mm. Protection class IP20