LCN-GT12C Issendorff KG

I-Connection Power Supply for Flush-Mounted Box The LCN-NUI is a power supply specifically designed for flush-mounted boxes, used to supply the LCN-GT switches via the I-connection.

This Tweezers The LCN-PINZ is a special tweezers designed for unlocking the LCN glass surface buttons. These buttons are equipped with a lateral locking pin that can be easily removed with the tweezers without causing damage. This greatly facilitates the installation and maintenance of the buttons. Application Examples Installation of LCN glass surface buttons Maintenance and replacement of buttons without damage Technical Data Ergonomic design for easy handling Material: High-quality plastic

Adapter for extending and duplicating the I-connection The LCN-IV is a versatile adapter used to extend and duplicate the I-connection. It allows the connection of up to two LCN-IV adapters to extend the I-connection with IY(ST)Y 2x2x0.8mm up to 50m. Additionally, the LCN-IVH functions as a pulse sensor that evaluates a 5V signal via potential-free contacts. Application Areas This adapter is ideal for applications where multiple sensors need to be operated on a bus module. It enables flexible and decentralized installation of sensors such as remote control receivers, temperature sensors, and binary sensors. Technical Data Frequency: maximum 500 Hz Dimensions: 14mm x 21mm x 12mm (W x L x H)

Sensor/Actuator Module for Flush-Mounted Box Combined sensor/actuator module with two electronic switching outputs 230V, 300VA. Dimmable in phase-cut or as a switch (switches at zero crossing). The 8 button inputs can individually control 64 target addresses with 192 functions. Integrated pulse measurement input for remote control receivers. The built-in operating program includes the following functions: switching and dimming the outputs, brightness and change speed adjustable separately. Includes programs for incandescent lamp dimming, blinds, gates, etc. Evaluation via 5 thresholds (=10 commands) with hysteresis. Includes 2 continuous controllers that can be used independently and additionally for threshold processing. Two measured values can be recorded and controlled independently of each other. Decoding of the telegrams of the IR remote control receiver or transponder. Evaluation directly or via central computer. Functions for button levels, coded transmission, sender differentiation. Additional functions: control with dependencies, formation of links, counting, calculating, fixed and dynamic group formation, generation of automatic status messages (real feedback) for visualization. LCN System Bus Functions Communication with up to 30,000 modules, max. 250 modules per bus level. Protocol with collision avoidance Documentation and parameterization retrievable in the module memory 100 light scene memories available per output Connection options for EIB/KNX touch sensors (standard), DSI-Dali interface, relays Overload protection, the outputs switch off the consumers in case of excessive loads Note: UPP modules must not be connected directly to roller shutter or blind motors! The end switches or the triacs in the module may be damaged. The use of the isolation relay LCN-R2U is recommended here. A filter (LCN-FI1) is mandatory as soon as the electronic outputs of the LCN-UPP are used as dimmers. The interference filter is connected between the module and the consumer, it dampens the interference occurring during dimming, thus ensuring compliance with CE standards. Technical Data Integrated power supply 230V ±15%, 0.4W, pulse-proof up to 4kV. Flush-mounted housing connection via approx. 20cm long single wires 0.75mm². Dimensions: 50mm Ø x 20mm. Protection class IP20